Xiaomi Redmi 5 Plus Remove MiAccount - FRP Done

Xiaomi Redmi 5 Plus Remove MiAccount - FRP Done
Xiaomi Redmi 5 Plus Remove MiAccount - FRP BY UMT

Mã:

@thanhnamPDAviet
Checking for existing devices...Found
Port : Qualcomm HS-USB QDLoader 9008 (COM3)
Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.1.2
Opening Port...OK
Invalid response from device!
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM3)
Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.1.2
Connecting to phone...OK
Waiting for response...Ignored
Init Handshake Sequence...OK
Hardware ID : E1600400 [8953] 00000000
OPK_DATA : 079E496E26A477B120DFCD85DF7E4AD067164D8292DDD379930D5891E3D8240B
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Firehose Loader...Done
Sending Loader [8953.ufl]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : 8953, eMMC, 64 GB
LU Count : 1 [0x0747C000] 
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 1048576, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : Xiaomi Redmi 5 Plus [msm8953]
Software : ZQL1711-vince-build-20180322161322, V9.5.3.0.NEGMIFA [Thu Mar 22 16:13:20 WIB 2018]
Android Ver. : 7.1.2
Patch Level : 2018-03-01
Resetting Mi Account Data...Done
Preparing Data...Done
Formatting Userdata...Done
When phone is completely ON, connect to Internet and add Mi Account.
-------------- INFORMATION --------------
New Firmware may cause hang on logo.
In such case, you need to flash phone to recover.
Or downgrade firmware and try Reset Mi Account again.
Operation Finished.

 

Kết nối wifi có bị relock ko ạ?

 

Không bạn nhé.Miui 9.6 vẫn done
Xiaomi Redmi 5 Plus Miui 9.6.2 Xóa Mi Account và FRP

Mã:

@thanhnamPDAviet
Operation : Reset Mi Account
Checking for existing devices...Found
Port : HS-USB Diagnostics 9008 (COM27)
Driver Info : Mobile, qcusbser.sys, 2.1.0.3
Opening Port...OK
Init Handshake Sequence...OK
Hardware ID : E1600400 [8953] 00000000
OPK_DATA : 079E496E26A477B120DFCD85DF7E4AD067164D8292DDD379930D5891E3D8240B
Initializing Protocol...OK
Using Auto Loader Selection [1]
Preparing Firehose Loader...Done
Sending Loader [8953.ufl]...Done
Executing Loader...OK
Detecting Chip Type...OK
Hardware : 8953, eMMC, 64 GB
LU Count : 1 [0x0747C000] 
WARNING! High Speed Driver is not installed.
Please install driver from QcFire\Drivers folder using Device Manager.
Payload Info : In: 65536 [4096], Out: 1048576, Sector Size: 512
Reading Partition Table...OK
Reading Device Information...OK
Device : Xiaomi Redmi 5 Plus [msm8953]
Software : ZQL1711-vince-build-20180608215524, V9.6.2.0.NEGMIFD [Fri Jun  8 21:55:22 WIB 2018]
Android Ver. : 7.1.2
Patch Level : 2018-05-01
Resetting Mi Account Data...Done
Preparing Data...Done
Formatting Userdata...Done
When phone is completely ON, connect to Internet and add Mi Account.
-------------- INFORMATION --------------
New Firmware may cause hang on logo.
In such case, you need to flash phone to recover.
Or downgrade firmware and try Reset Mi Account again.
Operation Finished.

 

nghe bảo sắp ra mui 10 rồi thi phải. 1 năm gặp 2 con, nên cũng chả có kèo

 

Tại sao e cũng làm UMT mà kết nối wifi hay 3g là bị nhỉ.

 

Chắc bản china + báo mất rồi

 

Vâng.chuẩn là bản china a à.

 

China dùng mrt ẩn apk thôi bồ