Waiting for device in fastboot mode ... 1. Power off device. Press and hold 'VOL DOWN' button 2. Insert USB cable, hold button until device will be found! Connect Ok! ADB activated! - > Info : Wait till device boot, make offline setup until device show message about protection - > Info : Re-connect cable, make "FRP Reset" in ADB tab! Done! Elapsed: 00:00:17 Operation : Reset FRP (ADB) [ v1.03 ] Waiting for device in ADB mode ... 1. Connect device, enable 'DEVELOPER MODE' and 'USB DEBUG', if need! 2. Insert USB cable, accept AUTH on PhoneScreen, if software ask! Device not found! Check cable, drivers and conection! Operation : Identify (ADB) [ v1.03 ] Waiting for device in ADB mode ... 1. Connect device, enable 'DEVELOPER MODE' and 'USB DEBUG', if need! 2. Insert USB cable, accept AUTH on PhoneScreen, if software ask! Connect Ok! Device Info : Vendor : asus Model : ASUS_Z017D Device : WW_Phone Android : 7.0 Product : ZE520KL Brand : asus Serial : G8AZCY10C6075NP Build_tm : Tue Oct 3 11:17:16 CST 2017 DisplayID : NRD90M.WW_Phone-14.2020.1709.68-20171003 Patch Ver : NRD90M SecPatch : 2017-09-01 Hardware : qcom HW Board : msm8953 CPU rel : arm64-v8a SIM Card : ABSENT,ABSENT BaseBand : M3.10.47.3-Leo_080001 BaseBand : M3.10.47.3-Leo_080001 RIL ver : Qualcomm RIL 1.0 USB Conf : mtp Sys USB : mtp,adb FS Crypt : encrypted Done! Elapsed: 00:00:08 Operation : Reset FRP (ADB) [ v1.03 ] Waiting for device in ADB mode ... 1. Connect device, enable 'DEVELOPER MODE' and 'USB DEBUG', if need! 2. Insert USB cable, accept AUTH on PhoneScreen, if software ask! Connect Ok! Device : WW_Phone Model : ASUS_Z017D FRP reset passed! Make FACTORY RESET from menu! Done! Elapsed: 00:00:04
