em dùng atf để sửa lỗi emmc con này,log atf báo done rồi mà em kẹp nguồn chỉ thấy kim đồng hồ dao động lên xuông thôi.sửa lỗi emmc xong có phải repair lại boot không ạ,đây là log của nó ace xem giúp em với 1. DO NOT USE THE PHONE"S BATTERY 2. Connect the Soldered TP Connections to ATF Box 3. Disconnect the USB Cable and Wait until the the ATF Software will tell you to Connect the USB. Interface Reset OK! eMMC Access Type: SECTOR MODE eMMC Supported Voltage Range: 3.5-3.6V, 3.4-3.5V, 3.3-3.4V, 3.2-3.3V, 3.1-3.2V 3.0-3.1V, 2.9-3.0V, 2.8-2.9V, 2.7-2.8V, 1.9-2.0V CID : 1501004D414732474106E11DEA92 CSD : D02701320F5903FFF6DBFFFF8A404007 eMMC Boot Information Revision 1.5 (for MMC v4.41) BOOT PARTITION : NOT BOOT ENABLED PARTITION ACCESS : R/W USER PARTITION PERM_BOOT_CFG_PROT : DISABLED PWR_BOOT_CFG_PROT : DISABLED BOOT MODE : x1 SINGLE DATA RATE + LOW SPEED RESET BUS WIDTH : ENABLED eMMC FirmW UPDATE : DISABLED EMMC CACHE SIZE : 0 KB SUPER PAGE SIZE : 3584 KB HC ERASE GROUP SIZE: 512 KB USER AREA SIZE : 15634268160 BYTES BOOT PARTITION SIZE: 2048 KB RPMB PARTITION SIZE: 128 KB eMMC Device Information Manufacturer ID: SAMSUNG Device Type : Embedded BGA Application ID : 00 Product Name : MAG2GA Product Rev : 0.6 Product SN : E11DEA92 Manufactured : January 2012 Card Specific Data CSD_STRUCTURE : Extended SPEC_VERS : Version 4.1/4.2/4.3 TAAC : 13 ns TRANS_SPEED : 4000000 KHz READ_BL_LEN : 512 Bytes C_SIZE : HIGH CAPACITY WP_GRP_ENABLE : YES WRITE_BL_LEN : 512 Bytes CONTENT_PROT_APP : NO PERM_WRITE_PROTECT: NO TMP_WRITE_PROTECT : NO Extended CSD Saved: 1501004D414732474106E11DEA92_3C484423.ext_csd Backup Directory: C:\AdvanceBox Turbo Flasher\eMMC\EXT_CSD\ Task Selected: Samsung Factory Format ====================================================== For eMMC Revision 1.5 (for MMC v4.41) and LOWER --> This will ERASE USER AREA, BOOT1, BOOT2, RPMB and EXT_CSD R/W/E Entries For eMMC Revision 1.6 (for MMC v4.5) and HIGHER --> This will ONLY ERASE USER AREA ====================================================== This eMMC is: Revision 1.5 (for MMC v4.41) Samsung Factory Format Start... Format Done! ====================================================== WARNING - WARNING - WARNING - WARNING - WARNING ====================================================== 1. WRITE Back EXT_CSD Backup if Needed 2. WRITE BOOT1 Image if Needed 3. WRITE BOOT2 Image if Needed 4. WRITE USER AREA Image if Needed ====================================================== Start Writing 0x00100000 Blocks at 0x00000000 Partition Selected: USER AREA Total Elapsed Time 00:14:48 Write Success!
